17.40.050, 17.40.110, 17.40.130, 17.40.160, 17.40.180
Dimensional standards
Servicing
- Applies near
- Hillside Development OverlayOverlay districtA second set of rules laid over the base district, adding requirements without replacing it.
- Geographic extent
- Flag lots allowed only in RS within Hillside Development (HD) Overlay DistrictOverlay districtA second set of rules laid over the base district, adding requirements without replacing it., not HD-1.
Extracted standards
10 individual requirements pulled out of this section’s prose, each with the sentence it came from.
Other
- Flag lot allowed only in RS within HD OverlayOverlay districtA second set of rules laid over the base district, adding requirements without replacing it.
A flag lot shall only be allowed on property zoned RS, and only within the Hillside Development (HD) Overlay District.
- Metallic finish solar reflectance limit in RS0.35 unitless
In RS, metallic finishes allowed when Solar Reflectance does not exceed 0.35; otherwise require Administrative Minor CUP.
- Flag lot pole width
Minimum 20 feet, maximum 25 feet of frontage and width for pole.
- Relocation requires minor CUP in RS
Minor Conditional Use Permit approval is required for relocation of a structure to a lot within the RS zoning district.
- Encroachment plane for RS30 degrees
Principal structures within RS shall not be located within a side setback encroachment plane sloping upward and inward at 30-degree angle from vertical, commencing 6 ft above grade.
- Fence heightMaximum heightThe tallest a building may be, given in feet, in storeys, or both — whichever binds first. abutting commercial/industrial8 ft
In interior side or rear setbacks abutting commercial/industrial with nonresidential use, max wall/fence height 8 ft.
- Fence heightMaximum heightThe tallest a building may be, given in feet, in storeys, or both — whichever binds first. abutting residential/OS/PS6 ft
In interior side or rear setbacks abutting OS/PS or residential, max wall/fence height 6 ft.
- Front fence heightMaximum heightThe tallest a building may be, given in feet, in storeys, or both — whichever binds first. in RS4 ft
Between front property line and occupancy frontage, max wall/fence height 4 ft, at least 50% open.
- Rear fence heightMaximum heightThe tallest a building may be, given in feet, in storeys, or both — whichever binds first. in RS6 ft
Rear setback max height 6 ft if located min 5 ft from street property line.
- Visibility triangle fence heightMaximum heightThe tallest a building may be, given in feet, in storeys, or both — whichever binds first.30 inches
Max height 30 inches within triangular area at driveway edge.
From the ordinance
Flag lot allowed only on RS within HD Overlay. Pole width 20-25 ft. Metallic finish allowed if SR <=0.35. Relocation requires minor CUP. Encroachment plane 30-degree from 6 ft. Wall/fence heights: 6 ft abutting OS/PS or residential, 8 ft abutting commercial/industrial, 4 ft front, etc.