zoneoptics
Culpeper, Virginia · General provision

Sec. 27-51

Single FamilyAll Culpeper districts0

Dimensional standards

lot requirementsSTREETSTREETFront 60 ftRear 40 ftSide 25 ftStreet side 60 ftMin width 150 ftMIN LOT AREA1 acMAX HEIGHT3 stories
Plan view of the district’s stated lot requirements. Solid line: the property line. Dashed: the setback lines the ordinance imposes; a building must stay inside the tinted envelope. Drawn from the figures extracted below — illustrative, not a survey.

Lot

Minimum lot areaMinimum lot areaThe smallest parcel on which the district allows anything to be built.
43,560 sq ftsq ftSquare feet. An acre is 43,560 sq ft; a typical suburban lot is 7,000–10,000. (1 acacre43,560 square feet — about the size of an American football field without the end zones.)
Minimum lot widthLot widthHow wide a lot must be, usually measured at the front setback line.
150 ft

SetbacksSetbackThe distance a building must be held back from a lot line.

FrontSetbackThe distance a building must be held back from a lot line.
60 ft
RearSetbackThe distance a building must be held back from a lot line.
40 ft
SideSetbackThe distance a building must be held back from a lot line.
25 ft
Street sideSetbackThe distance a building must be held back from a lot line.
60 ft

Height & bulk

Maximum storiesStoreysHabitable floor levels. Whether a basement or attic counts is defined by the local code.
3

Uses

Permitted by right2

Extracted standards

2 individual requirements pulled out of this section’s prose, each with the sentence it came from.

Other

From the ordinance

Minimum lot size 1 acre, lot width 150 ft, setback 60 ft, side yard 25 ft, rear yard 40 ft, height 3 stories.
Sec. 27-51