Los Angeles County Unincorporated, California · General provision

22.364.080.D.3

Dimensional standards

lot requirementsSTREETbuildable areaFront 1 ft
Plan view of the district’s stated lot requirements. Solid line: the property line. Dashed: the setback lines the ordinance imposes; a building must stay inside the tinted envelope. Drawn from the figures extracted below — illustrative, not a survey.

Height & bulk

Minimum landscaping
1%

Servicing

Applies near
Union Pacific
Geographic extent
East Los Angeles CSD, Union Pacific Sub-Area

Uses

Conditional / special use13

Extracted standards

2 individual requirements pulled out of this section’s prose, each with the sentence it came from.

Other

  • Climbing vines required

    Walls, view-obscuring fences, and buildings shall be landscaped with climbing vines or other similar plant material that can be trained on the fence, wall, or building and can be easily pruned and maintained to discourage graffiti and vandalism.

  • Walls, view-obscuring fences, and buildings shall be set back at least one foot from the property line and the development shall provide at least one square foot of landscaping for each linear foot of frontage on the front lot line or on a side lot line fronting a street

From the ordinance

In addition to the uses specified in Section 22.20.030... uses listed in Table 22.364.080-F, below, shall require a Conditional Use Permit (Chapter 22.158) application in Zone C-M.
22.364.080.D.3

Use details

{
  "dropped_conditions": {
    "conditional_uses": [
      "tool rentals, including rototillers, power mowers, sanders and saws, cement mixers, and other equipment, but excluding heavy machinery or trucks exceeding two tons' capacity, provided all activities are conducted within an enclosed building on Union Pacific Avenue only",
      "assembly and manufacture from previously prepared materials, excluding the use of drop hammers, automatic screw machines, punch presses exceeding five tons' capacity, and motors exceeding one-horsepower capacity that are used to operate lathes, drill presses, grinders, or metal cutters: aluminum products, stone products, metal plating, yarn products, excluding dyeing of yarn, shell products"
    ]
  }
}