22.362.030
Dimensional standards
Servicing
- Applies near
- Chapman Woods
- Geographic extent
- Chapman Woods community, as shown on Figure 22.362.030-A
Extracted standards
18 individual requirements pulled out of this section’s prose, each with the sentence it came from.
Fencing & walls
- ProhibitedProhibitedNot allowed in the district at all, short of rezoning or a variance. fence materials
Chain-link fence located in the front yard setback area... Exposed, unpainted, untreated board-formed concrete... Fences and walls constructed of or topped with spikes, wire, barbs, razors... Fences or walls constructed of glass... Tubular metal railings... Opaque driveways and pedestrian gates over 42 inches tall.
Lighting
- Lighting fixture requirement
All outdoor light fixtures shall be fully shielded downward directed light fixtures or frosted.
- Maximum freestanding light heightMaximum heightThe tallest a building may be, given in feet, in storeys, or both — whichever binds first.9 ft
The maximum height for a freestanding or pole-mounted light fixture or lamp post shall be nine feet in all yards.
- Maximum walkway light heightMaximum heightThe tallest a building may be, given in feet, in storeys, or both — whichever binds first.2 ft
The maximum height for lighting of walkways used for entry and exit to permitted structures, including parking areas, is two feet.
- Maximum wall-mounted light heightMaximum heightThe tallest a building may be, given in feet, in storeys, or both — whichever binds first.24 ft
The maximum height for light fixtures attached to the exterior façade of a residential structure, such as wall sconces, downlights, shall be 24 feet.
- Maximum security light wattage60 watts
Security lighting attached to the primary residential structure and other permitted structures shall be controlled by motion detectors and shall have a manufacturer's maximum output rating of no greater than 60 watts (600 lumens) or the equivalent.
Other
- Maximum eave projection36 in
Roof eaves and overhangs... are permitted to project into the required yard setbacks up to 36 inches from the edge of a façade.
- Landscape plan requirement
Where new planting areas, trees, ground cover, and landscape areas are proposed, the site plan, or a separate sheet, shall depict the locations and species of plant(s).
- Maximum entrance heightMaximum heightThe tallest a building may be, given in feet, in storeys, or both — whichever binds first.15 ft
Entrances and porches shall have an exterior maximum height of 15 feet, as measured to the highest point or roof ridge that comprises the porch roof.
- Optional architectural styles
Ranch, French Country, Colonial, Craftsman, Tudor Revival, Spanish Revival, Minimal Traditional
- Porch depth range
The depth of the projecting porch shall be a minimum of five feet and a maximum of 10 feet.
- Minimum porch open area48 sqftsq ftSquare feet. An acre is 43,560 sq ft; a typical suburban lot is 7,000–10,000.
The open area on the projecting porch shall provide a minimum size of 48 square feet.
- Minimum porch width8 ft
The minimum width of a projecting porch shall be eight feet.
The following materials are prohibited in the Chapman Woods CSD community... 1. The use of highly reflective materials... 2. Rust-finished metal siding... 3. Corrugated metal... 4. Exposed or protruding steel beams... 5. Exposed, unpainted, untreated 'cinder block'... 6. Board-formed concrete... 7. Heavy or glossy stone slabs... 8. Cargo shipping containers... 9. Glass walls and railing... 10. Asphalt paving... 11. Vinyl siding... 12. Reflective, glossy, or polished metallic roofing... 13. Tar and gravel roofs.
- ProhibitedProhibitedNot allowed in the district at all, short of rezoning or a variance. window materials
Dark tinted and mirrored glass, except for stained-glass windows; Glass block, except for stained-glass windows.
- Roof pitch range
Roofs on primary residential structures shall be pitched between 2:12 and 18:12.
- Window material requirements
All windows shall be comprised of non-glare/non-reflective glass or utilize methods to achieve non-reflectivity.
Signage
Outdoor advertising signs (Billboards); Freestanding signs that exceed 30 feet in height, extend into the public right-of-way, or are located within 100 feet of a residential zone... Roof signs.
From the ordinance
The boundaries of this CSD are shown on Figure 22.362.030-A: Chapman Woods CSD Boundary, at the end of this Chapter.