Los Angeles County Unincorporated, California · General provision
22.336.060.A.3.a and A.4.i
Dimensional standards
Servicing
- Geographic extent
- S1 habitat as designated on the Biological Resources Map
Uses
Conditional / special use1
Extracted standards
4 individual requirements pulled out of this section’s prose, each with the sentence it came from.
Other
- Habitat impact fee per acreacre43,560 square feet — about the size of an American football field without the end zones.83,478 dollars_per_acre
$83,478 per acre for the approved building site area, driveway/access roads and turnaround areas, any required irrigated fuel modification zones, and required off-site brush clearance areas
- Maximum building site area7,500 sqftsq ftSquare feet. An acre is 43,560 sq ft; a typical suburban lot is 7,000–10,000.
the maximum allowable building site area shall be 7,500 square feet, or 25 percent of the parcel size, whichever is less.
- Maximum slope in building site area25 pct
The BSA cannot contain any portion of the parcel with slopes of 25 percent or greater.
- Mitigation ratio for S1 habitat3 ratio
Mitigation for unavoidable permanent impacts to S1 habitat shall be provided, at a minimum, through the restoration and/or enhancement of like habitat type, at the ratio of 3:1 square feet of habitat to impacted area.
From the ordinance
All projects located entirely in S1 habitat shall require a SEA Conditional Use Permit. ... the maximum allowable building site area shall be 7,500 square feet, or 25 percent of the parcel size, whichever is less.