22.140.520.G.9.b.i
Dimensional standards
Height & bulk
- Minimum landscaping
- 20%
Extracted standards
19 individual requirements pulled out of this section’s prose, each with the sentence it came from.
Fencing & walls
- Minimum front fence transparencyGround-floor transparencyThe share of a ground-floor street wall that must be windows rather than blank surface.50 pct
Any fence in the front yard setback over 3 feet tall shall be a minimum of 50 percent transparent along the frontage.
- ProhibitedProhibitedNot allowed in the district at all, short of rezoning or a variance. fence materials
The use of barbed or razor wire, electrified fence, and chain-link fence in conjunction with any fence, wall, roof, or hedge is prohibited, unless required by any local, State, or federal regulation, as applicable.
Landscaping & trees
- Minimum landscaped area20 pct
A minimum of 20 percent of the lot area not used for buildings and structures, such as setbacks and open space, shall be landscaped with a combination of trees, ground cover, shrubbery, planters, or flowers.
- Minimum native or drought-tolerant plant percentage80 pct
At least 80 percent of the on-site landscaping coverage area shall consist of trees and plants native to southern California or non-invasive and drought tolerant, as approved by the Director.
Other
- ProhibitedProhibitedNot allowed in the district at all, short of rezoning or a variance. front yardYardThe open space left between a building and its lot line — the space a setback creates. utilities
Fire Department backflow prevention devices, water meters, transformers, and other utility-related equipment are prohibited in the front yard, unless completely screened in a manner that is incorporated into the design of the development.
- Maximum air conditioning unit projection6 in
Air conditioning units or vents located on the front façade shall not project more than six inches from the face of the building.
- ProhibitedProhibitedNot allowed in the district at all, short of rezoning or a variance. security grilles
Horizontally folding accordion grilles installed on the outside of a storefront are prohibited.
- Rooftop equipment screening
If on a rooftop or in a yard, the equipment shall be screened from view from the street with a wall, fence, or landscaping.
- Security bar installation location
When installed, all security bars or grilles shall be installed on the inside of the building.
Parking
- Alley access requirement
Alley-abutting lots shall use the alley for vehicle access.
- Maximum curb cutGrading (cut & fill)Reshaping land by removing earth (cut) or adding it (fill), often capped by volume. width for U-shaped driveway20 ft
A U-shaped common driveway may have two curb cuts on the primary street, each a maximum of 20 feet wide if the common driveway is one way.
- Bungalow court driveway shape
For bungalow courts, an L-shaped or U-shaped common driveway shall be permitted, if the development is a mid-block lot (not abutting on an alley or side street).
- Common driveway requirement
In addition to all requirements in Chapter 22.112 (Parking), developments shall provide shared common driveways for vehicular access.
- Common driveway shape requirement
For townhouses where on-site parking is provided, a T-shaped, I-shaped, or L-shaped shared private driveway shall be provided, if the development site sits on a mid-block lot (not abutting an alley).
- Driveway standard for shallow lots
When a property has a lot depth less than 90 feet and has primary street access, the standards for single-unit access shall be followed for driveway locations.
- Maximum garage frontageFrontageThe length of a lot line that touches a public street. percentage50 pct
Occupy no more than 50 percent of the total building frontage length of the dwelling unit and garage combined facing a street, unless the development is located on a narrow lot, as defined in Section 22.110.130.B (Required Width), in which case the garage facing the street shall occupy no more than 80 percent of the total building frontage length of the dwelling unit and garage combined facing the street.
- Maximum garage frontageFrontageThe length of a lot line that touches a public street. percentage on narrow lot80 pct
Occupy no more than 50 percent of the total building frontage length of the dwelling unit and garage combined facing a street, unless the development is located on a narrow lot, as defined in Section 22.110.130.B (Required Width), in which case the garage facing the street shall occupy no more than 80 percent of the total building frontage length of the dwelling unit and garage combined facing the street.
- Minimum landscape buffer around common driveway5 ft
A five-foot minimum landscape buffer shall be provided around the perimeter of the property adjacent to the common driveway, unless the common driveway is shared with an adjacent adjoining property.
- Parking access preference
If a development site is adjacent to an alley or corner, parking areas shall be accessed from the alley or side street except in the following conditions: (1) If the development site abuts an improved alley less than 20 feet wide; (2) If the development site sits on a corner lot with two street frontages and has a total gross building area of 200,000 square feet or more, parking access is allowed on both frontages; or (3) If the side street is classified as a major or secondary highway.
From the ordinance
A minimum of 20 percent of the lot area not used for buildings and structures, such as setbacks and open space, shall be landscaped with a combination of trees, ground cover, shrubbery, planters, or flowers.