Louisa County Unincorporated, Virginia · General provision

Sec. 86-506 through 86-517

Dimensional standards

Servicing

Applies near
Louisa County Airport and Lake Anna Airport
Geographic extent
Applies to all land beneath approach surfaces, transitional surfaces, horizontal surfaces and conical surfaces for Louisa County Airport and Lake Anna Airport

Extracted standards

6 individual requirements pulled out of this section’s prose, each with the sentence it came from.

Other

  • Conical zone slope20 ft outward per ft upward

    Slopes 20 feet outward for each foot upward, beginning at the periphery of the horizontal zone and at 150 feet above the airport elevation and extending to a height of 150 feet above the airport elevation.

  • Established at 150 feet above the airport elevation or at a height of 633 feet above mean sea level.

  • Precision instrument runway approach zone slope50 ft outward per ft upward

    Slopes 50 feet outward for each foot upward, beginning at the end of and at the same elevation as the primary surface and extending to a horizontal distance of 10,000 feet along the extended runway centerline; thence, slopes upward 40 feet horizontally for each foot vertically to an additional horizontal distance of 40,000 feet along the extended runway centerline.

  • ProhibitedProhibitedNot allowed in the district at all, short of rezoning or a variance. uses causing electrical interference, glare, bird strike hazards, etc.

    No use may be made of land or water within any zone established by this article in such a manner as to create electrical interference with navigational signals or radio communication between the airport and aircraft, make it difficult for pilots to distinguish between airport lights and others, result in glare in the eyes of pilots using the airport, impair visibility in the vicinity of the airport, create bird strike hazards, or otherwise in any way endanger or interfere with the landing, takeoff or maneuvering of aircraft intending to use the airport.

  • Transitional zone slope7 ft outward per ft upward

    Slopes seven feet outward for each foot upward, beginning at the sides of and at the same elevation as the primary surface and the approach surface and extending to a height of 150 feet above the airport elevation.

  • Utility runway nonprecision instrument approach zone slope20 ft outward per ft upward

    Slopes 20 feet outward for each foot upward, beginning at the end of and at the same elevation as the primary surface and extending to a horizontal distance of 5,000 feet along the extended runway centerline.

From the ordinance

No structure shall be erected, altered or maintained and no tree shall be allowed to grow in any zone created by this article to a height in excess of the applicable height limit.
Sec. 86-506 through 86-517