Extracted standards
5 individual requirements pulled out of this section’s prose, each with the sentence it came from.
Other
- Survey marker diameter0.5 in
a minimum of one-half inch in diameter
- Survey marker length15 in
and 15 inches long
- Survey marker material
Survey markers shall be iron or steel pins...
- Survey marker placement
driven so as to be flush with finished grades at all street corners, angles in streets, the beginning and end of all curves in streets, at all points where the street intersects the exterior boundaries, all lot corners and angles, all points where the lot lines intersect the right-of-way along street curves and all points where street rights-of-way cross municipal boundaries.
- Survey marker installation in rock4 in
Where rock is encountered, a hole shall be drilled four inches deep, into which shall be cemented a steel rod one-half inch in diameter, the top of which shall be flush with the finished grade line.
From the ordinance
Survey markers shall be iron or steel pins a minimum of one-half inch in diameter, and 15 inches long and driven so as to be flush with finished grades at all street corners...