zoneoptics
San Marcos, California · District

I-1

General Industrial
IndustrialGeneral IndustrialAll San Marcos districts0

Dimensional standards

I-1 lot requirementsSTREETbuildable areaFront 10 ftRear 0 ftSide 0 ftMAX HEIGHT45 ftMAX FAR0.5
Plan view of the district’s stated lot requirements. Solid line: the property line. Dashed: the setback lines the ordinance imposes; a building must stay inside the tinted envelope. Drawn from the figures extracted below — illustrative, not a survey.

Lot

Minimum lot widthLot widthHow wide a lot must be, usually measured at the front setback line.
0 ft

SetbacksSetbackThe distance a building must be held back from a lot line.

FrontSetbackThe distance a building must be held back from a lot line.
10 ft
RearSetbackThe distance a building must be held back from a lot line.
0 ft
SideSetbackThe distance a building must be held back from a lot line.
0 ft

Height & bulk

Maximum heightMaximum heightThe tallest a building may be, given in feet, in storeys, or both — whichever binds first.
45 ft
Maximum floor area ratioFloor area ratio (FAR)Total floor area divided by lot area — an FAR of 2.0 permits 20,000 sq ft of floor on a 10,000 sq ft lot.
0.5

Uses

Permitted by right44

Conditional / special use12

Accessory3

Prohibited1

From the ordinance

Floor-Area Ratio 0.5; Maximum Height 45 feet; Street Frontage PL Buildings/Structures 10 feet; Interior PL Building 0 feet; Walls and Fencing Height 6 feet minimum height; 10 feet maximum height
Table 20.230-2; Table 20.230-3