Sec. 18-396(a)(2)
Dimensional standards
Servicing
- Geographic extent
- Areas within the AE Zone on the FIRM where the floodway has not been delineated, for which one-percent annual chance flood elevations have been provided.
Extracted standards
2 individual requirements pulled out of this section’s prose, each with the sentence it came from.
Other
- CLOMR required for development increasing BFE
Development activities in Zones A1-30, AE, or AH on the local FIRM which increase the water surface elevation of the base flood by more than one (1) foot may be allowed, provided that the applicant first applies—with local government endorsement—for a conditional letter of map revision, and receives the approval of the Federal Emergency Management Agency. (Sec. 18-396(a)(2))
- No development increasing BFE more than 1 foot1 ft
Until a regulatory floodway is designated, no new construction, substantial improvements, or other development (including fill) shall be permitted within the areas of special flood hazard, designated as Zones A1-30, AE, or AH on the FIRM, unless it is demonstrated that the cumulative effect of the proposed development, when combined with all other existing and anticipated development, will not increase the water surface elevation of the base flood more than one (1) foot at any point within the community. (Sec. 18-396(a)(2))
From the ordinance
Until a regulatory floodway is designated, no new construction, substantial improvements, or other development (including fill) shall be permitted within the areas of special flood hazard, designated as Zones A1-30, AE, or AH on the FIRM, unless it is demonstrated that the cumulative effect of the proposed development, when combined with all other existing and anticipated development, will not increase the water surface elevation of the base flood more than one (1) foot at any point within the community.