Dimensional standards
Lot
Servicing
- Geographic extent
- R, RO and HO districts
Extracted standards
3 individual requirements pulled out of this section’s prose, each with the sentence it came from.
Other
- Two-family attached density bonusDensity bonusExtra units allowed above the base cap in exchange for something — usually affordable homes.20 pct
The minimum required lot area and lot width applicable to two-family attached dwellings shall be reduced by up to 20 percent
- Minimum lot areaMinimum lot areaThe smallest parcel on which the district allows anything to be built. after density bonusDensity bonusExtra units allowed above the base cap in exchange for something — usually affordable homes.2,600 sqftsq ftSquare feet. An acre is 43,560 sq ft; a typical suburban lot is 7,000–10,000.
in no case shall the lot area be less than 2,600 square feet
- Minimum lot widthLot widthHow wide a lot must be, usually measured at the front setback line. after density bonusDensity bonusExtra units allowed above the base cap in exchange for something — usually affordable homes.23 ft
nor shall the lot width be less than 23 feet
From the ordinance
The minimum required lot area and lot width applicable to two-family attached dwellings shall be reduced by up to 20 percent, provided that not less than 11 percent of the total number of two-family attached dwellings developed on the site, including the optional density increase, are affordable dwelling units, and provided further that in no case shall the lot area be less than 2,600 square feet, nor shall the lot width be less than 23 feet.