Sec 70-851
Dimensional standards
Height & bulk
Servicing
- Applies near
- Madison-Barbour Rural Historic DistrictHistoric districtAn area where exterior changes need design review to protect its character., Germanna Highway, Virginia Scenic Byway, historicHistoric districtAn area where exterior changes need design review to protect its character. properties
- Geographic extent
- Within Madison-Barbour Rural Historic DistrictHistoric districtAn area where exterior changes need design review to protect its character., within 250 feet of centerline of any primary or secondary road, within 500 feet of right-of-way of Germanna Highway (Route 3), within 1000 feet of right-of-way of a Virginia Scenic Byway, or within 1000 feet of any specific property listed on the National Register of HistoricHistoric districtAn area where exterior changes need design review to protect its character. Places or the Virginia Landmarks Register
Extracted standards
4 individual requirements pulled out of this section’s prose, each with the sentence it came from.
Other
- SetbackSetbackThe distance a building must be held back from a lot line. with breakpoint technology
The Zoning Administrator may reduce the setback requirement from existing buildings provided the design of the TAS incorporates breakpoint technology. In this case, the setback from buildings shall be equal to one-hundred and ten percent (110%) of the distance from the highest point of the TAS to its breakpoint location.
- Concealment required in sensitive areas
If the TAS is located within the Madison-Barbour Rural Historic District, within two-hundred fifty (250) feet of the centerline of any primary or secondary road, within five-hundred (500) feet of the right-of-way of Germanna Highway (Route 3), within one-thousand (1,000) feet of the right-of-way of a Virginia Scenic Byway, or within one-thousand (1,000) feet of any specific property listed on the National Register of Historic Places or the Virginia Landmarks Register, concealment of the TAS shall be required.
- Maximum base width for self-supporting TAS36 in
The TAS shall be either a monopole design or a self-supporting design with a maximum base width of thirty-six (36) inches.
- SetbackSetbackThe distance a building must be held back from a lot line. from off-site buildings equal to heightMaximum heightThe tallest a building may be, given in feet, in storeys, or both — whichever binds first. of TAS
The TAS and any related ground-mounted facilities shall comply with the minimum setback and yard requirements of the underlying zoning district, and shall also be setback from all existing off-site buildings a distance equal to the height of the TAS.
From the ordinance
The total maximum height of a TAS eligible for administrative approval shall not exceed one-hundred (100) feet in all zoning districts.