Sec. 24-101(c)
Dimensional standards
Extracted standards
5 individual requirements pulled out of this section’s prose, each with the sentence it came from.
Other
- Landscape area adjacent to buildings10 ft
A landscape area which is a minimum of ten feet wide shall be provided adjacent to one-half of the perimeter of the building.
- Industrial uses exempt from 2.5 inch caliper requirement
For all uses in RT, none of the deciduous trees shall be required to be of a 2.5 inch minimum caliper.
- Maximum imperviousImpervious coverageThe share of a lot covered by anything water cannot soak through — roofs, drives, patios. cover60 pct
Impervious cover shall not exceed 60 percent of the lot area except where an exception is approved.
- Rear landscape area reduction for certain lots10 ft
Along the rear property lines, such landscape area may be reduced to a minimum of ten feet in width or five percent of the average lot depth, whichever is greater, on lots less than 65,000 square feet which were recorded or legally in existence prior to July 3, 1990.
- Side and rear landscape area width15 ft
A landscape area adjoining all side and rear property lines shall be provided which is at least 15 feet in width.
From the ordinance
A landscape area adjoining all side and rear property lines shall be provided which is at least 15 feet in width... impervious cover shall not exceed 60 percent of the lot area...