Sec. 22-154, 22-156, 22-157, 22-158, 22-159, 22-161, 22-163
Dimensional standards
Lot
Density
Height & bulk
Housing
- Three-family
- by_right
- Four-plus family
- by_right
Uses
Permitted by right19
Conditional / special use5
Accessory1
Prohibited3
Extracted standards
5 individual requirements pulled out of this section’s prose, each with the sentence it came from.
Density
- Maximum multifamilyMultifamily dwellingA building of four or more dwelling units. Where zoning is most restrictive. percentage60 pct
A maximum of 60 percent of the total number of dwelling units developed within a planned residential development may be multifamily dwellings.
Other
- Minimum project area50 acresacre43,560 square feet — about the size of an American football field without the end zones.
The gross area of the tract of land to be developed under the planned residential district shall be 50 contiguous acres.
- Perimeter buffer
Buffer space along the perimeter of a planned residential development district shall be in substantial compliance with yard and setback standards applicable in other zoning districts in which comparable land uses are commonly found.
- Transitional yardYardThe open space left between a building and its lot line — the space a setback creates. for nonresidential uses10 ft
Whenever any nonresidential use is established in this district on a lot which adjoins any other lot proposed to be residentially developed, a transitional yard shall be provided on such lot by the nonresidential use along such common boundary to a depth of ten feet, and screening shall be provided within such yard.
- Underground utilities required
Underground utilities, including telephone and electrical systems, are required within the limits of all planned residential developments.
From the ordinance
A minimum of 20 percent of the net land area of the development shall be reserved for common open space.