Riverside County Unincorporated, California · General provision

17.105.070 (2)

Dimensional standards

lot requirementsSTREETSTREETbuildable areaRear 10 ftSide 3 ftStreet side 10 ftMin width 60 ftMin depth 100 ftMIN LOT AREA6,000 sq ftMIN FRONTAGE60 ftMAX LOT COVERAGE60%
Plan view of the district’s stated lot requirements. Solid line: the property line. Dashed: the setback lines the ordinance imposes; a building must stay inside the tinted envelope. Drawn from the figures extracted below — illustrative, not a survey.

Uses

Permitted by right2

Extracted standards

12 individual requirements pulled out of this section’s prose, each with the sentence it came from.

Other

From the ordinance

Lot area shall be not less than six thousand (6,000) square feet, unless cluster development subject to the development standards set forth in subsection AA. through GG. of this section is utilized. ... The minimum average width of that portion of a lot to be used as a building site shall be sixty (60) feet, with a minimum average depth of one hundred (100) feet ... The minimum frontage of a lot shall be sixty (60) feet ... Side yards on interior and through lots shall be not less than ten (10) percent of the width of the lot, but not less than three feet in width in any event, and need not exceed a width of five feet ... The rear yard shall not be less than ten (10) feet ... In no case shall more than sixty (60) percent of any lot be covered by buildings or structures.
17.105.070 (2)

Use details

{
  "dropped_conditions": {
    "permitted_uses": [
      "two family dwellings developed pursuant to subsection AA. through GG. of this section"
    ]
  }
}