zoneoptics
Riverside County Unincorporated, California · District

PA-25

Planning Area 25, Specific Plan No. 260
ResidentialAll Riverside County Unincorporated districts0

Dimensional standards

PA-25 lot requirementsSTREETbuildable areaFront 12 ftSide 4 ftMin width 40 ftMin depth 75 ftMIN LOT AREA3,500 sq ftMIN FRONTAGE40 ftMAX LOT COVERAGE60%
Plan view of the district’s stated lot requirements. Solid line: the property line. Dashed: the setback lines the ordinance imposes; a building must stay inside the tinted envelope. Drawn from the figures extracted below — illustrative, not a survey.

Lot

Minimum lot areaMinimum lot areaThe smallest parcel on which the district allows anything to be built.
3,500 sq ftsq ftSquare feet. An acre is 43,560 sq ft; a typical suburban lot is 7,000–10,000.
Minimum lot widthLot widthHow wide a lot must be, usually measured at the front setback line.
40 ft
Minimum frontageFrontageThe length of a lot line that touches a public street.
40 ft
Minimum lot depth
75 ft

SetbacksSetbackThe distance a building must be held back from a lot line.

FrontSetbackThe distance a building must be held back from a lot line.
12 ft
SideSetbackThe distance a building must be held back from a lot line.
4 ft

Height & bulk

Maximum lot coverageLot coverageThe share of a lot that buildings may cover, as a percentage.
60%

Extracted standards

3 individual requirements pulled out of this section’s prose, each with the sentence it came from.

Other

From the ordinance

Lot area shall be not less than three thousand five hundred (3,500) square feet. ... minimum average width ... forty (40) feet with a minimum average depth of seventy-five (75) feet. ... front yard for living areas and porches shall be not less than twelve (12) feet ... side yards on interior and through lots shall be not less than four feet ... In no case shall more than sixty-five (65) percent of any lot be covered by buildings for lots with one-story buildings and in no case shall more than sixty (60) percent ...
17.73.020