zoneoptics
Riverside County Unincorporated, California · General provision

17.78.100

All Riverside County Unincorporated districts0

Dimensional standards

lot requirementsSTREETSTREETSide 5 ftStreet side 10 ftMin width 45 ftMin depth 90 ftMIN LOT AREA5,000 sq ftMIN FRONTAGE45 ftMAX LOT COVERAGE45%
Plan view of the district’s stated lot requirements. Solid line: the property line. Dashed: the setback lines the ordinance imposes; a building must stay inside the tinted envelope. Drawn from the figures extracted below — illustrative, not a survey.

Lot

Minimum lot areaMinimum lot areaThe smallest parcel on which the district allows anything to be built.
5,000 sq ftsq ftSquare feet. An acre is 43,560 sq ft; a typical suburban lot is 7,000–10,000.
Minimum lot widthLot widthHow wide a lot must be, usually measured at the front setback line.
45 ft
Minimum frontageFrontageThe length of a lot line that touches a public street.
45 ft
Minimum lot depth
90 ft

SetbacksSetbackThe distance a building must be held back from a lot line.

SideSetbackThe distance a building must be held back from a lot line.
5 ft
Street sideSetbackThe distance a building must be held back from a lot line.
10 ft

Height & bulk

Maximum lot coverageLot coverageThe share of a lot that buildings may cover, as a percentage.
45%

Extracted standards

3 individual requirements pulled out of this section’s prose, each with the sentence it came from.

Other

From the ordinance

Lot area shall be not less than five thousand (5,000) square feet. ... The minimum average width ... forty-five (45) feet ... depth of ninety (90) feet. ... Side yards on interior and through lots shall be not less than five feet in width. ... In no case shall more than fifty (50) percent of any lot be covered by buildings or structures that are single-story and forty-five (45) percent for two-story.
17.78.100