R-1
Dimensional standards
Height & bulk
Housing
- Two-family
- by_right
- Three-family
- by_right
- Four-plus family
- by_right
Uses
Extracted standards
5 individual requirements pulled out of this section’s prose, each with the sentence it came from.
Height
- HeightMaximum heightThe tallest a building may be, given in feet, in storeys, or both — whichever binds first. condition for multifamilyMultifamily dwellingA building of four or more dwelling units. Where zoning is most restrictive.
No multifamily structure in the R-1 district shall exceed 35 feet in height or three stories, when designed with one-half or more of the ground floor below grade.
Other
- Ancillary use location
Ancillary uses and structures shall be permitted only if a primary structure is present and must be located in the rear of the primary structure.
- Existing lot sizes continue
Lot sizes in R-1 districts in effect on November 12, 1992, shall continue. No decrease in size of lots shall be allowed without council approval.
- Mobile homeManufactured homeA dwelling built in a factory to a federal standard and transported to the site. restrictions
No new mobile home sites or spaces are allowed anywhere within the town. No mobile home that exists on the effective date of this Code may be replaced by another mobile home.
- Permit expiration period6 months
All applications and permits for a change of use of the property and zoning for new construction or addition shall expire after six months from date of issuance of the permit or approval of the application, if substantial construction has not commenced.
From the ordinance
In the R-1 residential district, structures to be erected or land to be used shall be for one or more of the following uses: single-family, multifamily structures... No multifamily structure shall exceed 35 feet in height or three stories... Ancillary uses shall be permitted only if a primary structure is present and must be located in the rear.