Signal Hill

Double-faced signs shall count as one sign. Signs located at the intersection of any two streets... shall be placed so as not to create a visual blockage... Signs shall be maintained in a neat, clean, orderly and safe manner at all times. In each instance and under the same conditions in which this chapter permits any sign, a noncommercial sign constructed to the same physical dimensions and characteristics shall be permitted in lieu of that sign.

Major highways as designed on the 'Official Plan Lines Map of the City of Signal Hill' shall have a minimum right-of-way width of one hundred feet.

Secondary highways as designated on the 'Official Plan Lines Map of the City of Signal Hill' shall have a minimum right-of-way width of eighty feet.

Secondary modified highways as designated on the 'Official Plan Lines Map of the City of Signal Hill' shall have a minimum right-of-way width of seventy feet.

Local streets as designated on the 'Official Plan Lines Map of the City of Signal Hill' shall have a minimum right-of-way width of sixty feet.

Alleys as designated on the 'Official Plan Lines Map of the City of Signal Hill' shall have a minimum right-of-way width of twenty feet.

Pedestrian Connection as designated on the 'Official Plan Lines Map of the City of Signal Hill' shall include public right-of-way for pedestrian access.

Development in each study area shall include a complete traffic analysis of the study area, prepared by a registered traffic engineer for review and approval by the city engineer.

No building, structure or other improvement, whether publicly or privately owned, shall be erected, altered, moved in or placed within the official plan lines of streets and highways as adopted by this chapter.

The city engineer may make minor reductions to any of the standards contained herein of up to five percent of the right-of-way width, except for the drivable width of streets and alleys.

When practical difficulties, unnecessary hardships or results inconsistent with the general purpose of this chapter occur through a strict interpretation of the provisions hereof, the planning commission may initiate proceedings for consideration of a variance from the terms of this chapter.

An urban lot split must satisfy each of the following requirements: ... Lot size: The lot to be split must be at least 2,400 square feet. The resulting lots must each be at least 1,200 square feet.

five hundred sixty square feet of land per single-family dwelling unit and three hundred eighty-five square feet of land per multiple-family dwelling unit shall be dedicated.

A preliminary soils report... shall be required for every subdivision for which a final tract or final parcel map is required.

Security to guarantee the performance of any act or agreement shall be in the following amounts: An amount determined by the city engineer equal to one hundred percent of the total estimated cost...

Any use not specifically listed shall be prohibited. No place of public assemblage, institution, or school shall be erected within three hundred feet of any oil well that has not been abandoned.

In each residential district, each lot shall comply with lot area and dimension standards contained in Chapter 20.66, and shall have the minimum area and dimensions shown below.

All storage yards and outdoor storage areas shall be enclosed by a fence, wall, or gate... Fences shall be new six to eight foot high chain link fences... Storage shall be setback a minimum five feet from the property line when adjacent to residential zones.

The following standards shall apply to all trucking yards: ...

Purpose: ... accessory uses on properties outside of the SP-4 Auto Center Specific Plan ... in the industrial zoning districts.