Mount Shasta, California · General provision
Table 1 – Resource Lands (R-L), Sections 1.3-1.7
Resource LandsAll Mount Shasta districts0
Dimensional standards
Lot
- Minimum lot areaMinimum lot areaThe smallest parcel on which the district allows anything to be built.
- 21,780 sq ftsq ftSquare feet. An acre is 43,560 sq ft; a typical suburban lot is 7,000–10,000. (0.5 acacre43,560 square feet — about the size of an American football field without the end zones.)
- Minimum lot depth
- 3 ft
Density
- Maximum density
- 0.1 du/acredu/acreDwelling units per acre — the number of homes allowed on each acre of land.
- Lot area per dwelling unitLot area per dwelling unitLand required for each home — the same limit as du/acre, expressed per unit instead of per acre.
- 435,600 sq ftsq ftSquare feet. An acre is 43,560 sq ft; a typical suburban lot is 7,000–10,000. (10 acacre43,560 square feet — about the size of an American football field without the end zones.)
Uses
Permitted by right3
Conditional / special use11
- Airport, heliport
- Agriculture
- Commercial stable
- Contractor's equipment yard
- Feed lots, slaughter houses, livestock transshipment facilities
- Group care home of more than six clients
- Kennels
- Mineral resource extraction and production
- Places of assembly or learning (church, grange halls, community centers, schools)
- Public and quasi-public facilities (electrical substations, fire/police stations, parks, wastewater/water treatment)
- Large animals (one per acre)
Extracted standards
1 individual requirements pulled out of this section’s prose, each with the sentence it came from.
Other
- Maximum lot depth to width ratio3 ratio
The lot depth shall not exceed three times the width
From the ordinance
Maximum residential density: One dwelling unit per 10 acres. Minimum parcel size: One-half acre.