zoneoptics
Mount Shasta, California · District

R-1

Low Density Residential
ResidentialSingle FamilyAll Mount Shasta districts0

Dimensional standards

R-1 lot requirementsSTREETMin depth 3 ftMIN LOT AREA6,000 sq ftMAX DENSITY6 du/ac
Plan view of the district’s stated lot requirements. Solid line: the property line. Dashed: the setback lines the ordinance imposes; a building must stay inside the tinted envelope. Drawn from the figures extracted below — illustrative, not a survey.

Lot

Minimum lot areaMinimum lot areaThe smallest parcel on which the district allows anything to be built.
6,000 sq ftsq ftSquare feet. An acre is 43,560 sq ft; a typical suburban lot is 7,000–10,000.
Minimum lot depth
3 ft

Density

Maximum density
6 du/acredu/acreDwelling units per acre — the number of homes allowed on each acre of land.
Lot area per dwelling unitLot area per dwelling unitLand required for each home — the same limit as du/acre, expressed per unit instead of per acre.
6,000 sq ftsq ftSquare feet. An acre is 43,560 sq ft; a typical suburban lot is 7,000–10,000.

Housing

Single-familySingle-family dwellingOne dwelling unit on its own lot, usually detached from its neighbours.
by_right
Two-family
prohibitedProhibitedNot allowed in the district at all, short of rezoning or a variance.
Three-family
prohibitedProhibitedNot allowed in the district at all, short of rezoning or a variance.
Four-plus family
prohibitedProhibitedNot allowed in the district at all, short of rezoning or a variance.

Uses

Permitted by right4

Conditional / special use3

  • Places of assembly or learning (church, community centers, schools)
  • Public and quasi-public facilities (electrical substations, parks, playgrounds)
  • Senior and assisted housing

Accessory5

Extracted standards

1 individual requirements pulled out of this section’s prose, each with the sentence it came from.

Other

  • Maximum lot depth to width ratio3 ratio

    The lot depth shall not exceed three times the width

From the ordinance

Maximum residential density: Six dwelling units per gross acre. Minimum Parcel Size: 6,000 square feet.
Table 4 – Low Density Residential (R-1), Sections 4.3-4.7