18.26.020, 18.26.030
Dimensional standards
Uses
Permitted by right6
Conditional / special use14
- Colleges and Trade Schools
- Community Assembly
- Parks and Recreational Facilities
- Public Safety Facilities
- Animal Boarding
- Plant Nurseries
- Building Materials
- Home Improvement Centers
- Large Commodity Retail
- Warehousing and Distribution with Outdoor Storage
- Recycling Collection Facility
- Instructional Services
- Veterinarian Clinics and Hospitals
- Cinemas and Theaters
Prohibited14
- Caretaker Quarters
- Medical Offices and Clinics
- Commercial Recreation, Indoor
- Eating and Drinking Uses
- Salvage and Wrecking
- Towing and Impound
- Vehicle Repair and Maintenance, Major
- Food and Beverage Production
- Manufacturing, General
- Heavy Distribution
- Parcel Sorting Facilities
- Recycling Processing Facility
- Utilities, Major
- Crop Cultivation
Extracted standards
7 individual requirements pulled out of this section’s prose, each with the sentence it came from.
Other
- Maximum accessory useAccessory useA secondary activity customarily incidental to the main use of the lot — a garage, a home office. floor area3,000 sqftsq ftSquare feet. An acre is 43,560 sq ft; a typical suburban lot is 7,000–10,000.
The use is limited to no more than three thousand square feet or ten percent of the floor area of the primary use, whichever is less.
- Maximum retail display area for automotive products25 pct
Retail sale of automotive products allowed only when ancillary to a vehicle repair and maintenance use. Retail display areas for automotive products may not exceed twenty-five percent of the building floor area.
- Minimum cul-de-sac lot widthLot widthHow wide a lot must be, usually measured at the front setback line.80 ft
In all industrial zoning districts except for the IC zoning district, the minimum width of a cul-de-sac lot is eighty feet as measured along the radius of the front property line.
- Maximum FARFloor area ratio (FAR)Total floor area divided by lot area — an FAR of 2.0 permits 20,000 sq ft of floor on a 10,000 sq ft lot. for industrial uses0.6 ratio
An FAR of 0.6 is allowed for industrial uses.
- Maximum FARFloor area ratio (FAR)Total floor area divided by lot area — an FAR of 2.0 permits 20,000 sq ft of floor on a 10,000 sq ft lot. for non-industrial uses0.5 ratio
An FAR of 0.5 is allowed for non-industrial land uses.
- Outdoor uses screening
In all other industrial zoning districts, outdoor uses shall be screened from public view and the area containing the outdoor use shall meet the minimum design standards applicable to off-street parking facilities as specified in Section 18.72.060.
- Residential transition standards
Where a property abuts a residential zoning district or residential land use designation, the property shall comply with increased setbacks, upper story stepbacks, and landscaping standards as specified in Section 18.92.130.
From the ordinance
Table 18.26-1: Permitted Land Uses; Table 18.26-2: Development Standards. FAR 0.6 for industrial uses, 0.5 for non-industrial. Cul-de-sac lot width 80 ft.