Dendron, Virginia · General provision

Sec. 3-1401 to 3-1404

Dimensional standards

Servicing

Applies near
James River Watershed
Applies within
100 ft
Geographic extent
Chesapeake Bay Preservation Areas including Resource Protection Areas (RPA) and Resource Management Areas (RMA) within the James River Watershed

Extracted standards

13 individual requirements pulled out of this section’s prose, each with the sentence it came from.

Floodplain

Other

  • Achieve a 40 percent reduction in nonpoint source pollution from agricultural and silvicultural uses.

  • No encroachment in seaward 50 feet of buffer50 ft

    The encroachment may not extend into the seaward 50 feet of the buffer area.

  • Buffer nutrient reduction40 pct

    The 100-foot RPA buffer shall be deemed to achieve a 40 percent reduction of nutrients.

  • Buffer sediment reduction75 pct

    The 100-foot RPA buffer shall be deemed to achieve a 75 percent reduction of sediments.

  • All development and redevelopment exceeding 2,500 square feet shall be subject to applicable provisions.

  • All land development shall minimize impervious cover consistent with the use or development proposed.

  • Redevelopment pollution reduction10 pct

    Achieve a ten percent reduction in nonpoint source pollution from redevelopment.

  • Reserve sewage disposal site required

    For new construction, provide a reserve sewage disposal site with a capacity at least equal to that of the primary sewage disposal site.

  • RMA slope threshold15 pct

    Slopes in excess of 15 percent are RMA features.

  • RPA buffer width100 ft

    A buffer area not less than 100 feet in width located adjacent to and landward of the components...

  • Septic pump-out frequency5 years

    All on-site sewage disposal systems not requiring VPDES permit shall be pumped out at least once every five years.

  • Water quality impact assessment required

    A water quality impact assessment shall be required for any proposed land disturbance within an RPA.

From the ordinance

A buffer area not less than 100 feet in width located adjacent to and landward of the components...
Sec. 3-1401 to 3-1404