AI-1
Dimensional standards
Uses
Prohibited23
- Any residential use other than permitted caretaker housing
- Ammonia, chlorine or bleaching powder manufacture
- Animal slaughtering
- Asphalt batching plant and rock, sand and gravel pit crushing and screening plant
- Automobile wrecking, dismantling, and salvage yards
- Bone, coal or wood distillation
- Brick, tile or clay products manufacture
- Explosive manufacture or storage
- Fat rendering
- Fertilizer manufacture
- Foundry or smelting of ferrous metals, steel mill or boiler works
- Garbage, offal, dead animal or refuse incineration, reduction or dumping
- Glue manufacture
- Hydrochloric, nitric or sulfuric acid manufacture
- Junk, rag or scrap iron storage yards or bailing
- Petroleum refining or petroleum products manufacture
- Rock, sand or gravel excavating
- Rubber or gutta-percha manufacture
- Soap manufacture
- Stockyard, cattle-feeding yard or hog ranch
- Tallow, grease or lard manufacture or refining
- Tanning, curing or storing of raw hides or skins
- Other uses that, by written decision of the Community & Economic Development Director or his/her designee, are determined to be detrimental to the public welfare by reason of the emission of odor, dust, smoke, gas, noise, vibration or other causes
Extracted standards
6 individual requirements pulled out of this section’s prose, each with the sentence it came from.
Fencing & walls
- Minimum wall heightMaximum heightThe tallest a building may be, given in feet, in storeys, or both — whichever binds first. when adjacent to residential8 ft
Wherever a lot or parcel in any industrial zone abuts a Residential Zone or use, or abuts an alley that separates the industrial zone from a Residential Zone or use, a minimum eight-foot high solid masonry wall shall be constructed along the property line or alley right-of-way line separating the industrial zone from the Residential Zone or use.
Other
- Design review required
No new building, structure or sign or exterior alteration or enlargement of an existing building, structure or sign shall be commenced in any industrial zone until design review approval has been granted pursuant to Chapter 19.710 (Design Review).
- No penetration of flight zone
No building, structure or tree may penetrate the flight zone of an airport per the "imaginary surfaces" established by Federal Aviation Regulations FAR Part 77.25.
- Front yardYardThe open space left between a building and its lot line — the space a setback creates. setbackSetbackThe distance a building must be held back from a lot line. when adjacent to residential50 ft
A minimum front yard setback of 50 feet shall be required and maintained wherever a lot or parcel in any industrial zone abuts or is adjacent to a lot or parcel in any residential zone or use.
- Health Risk Assessment required within distance of residential1,000 ft
A Health Risk Assessment (HRA) shall be prepared in accordance with South Coast Air Quality Management District (SCAQMD) Guideline for the new development or substantial enlargement of industrial uses within 1,000 feet of a Residential Zone or use.
- Side or rear yardYardThe open space left between a building and its lot line — the space a setback creates. setbackSetbackThe distance a building must be held back from a lot line. when adjacent to residential50 ft
The side or rear yard setback shall be the same as the required front yard setback wherever a side or rear yard abuts any lot zoned for residential use.
From the ordinance
The side or rear yard setback shall be the same as the required front yard setback wherever a side or rear yard abuts any lot zoned for residential use. A minimum front yard setback of 50 feet shall be required and maintained wherever a lot or parcel in any industrial zone abuts or is adjacent to a lot or parcel in any residential zone or use.
Use details
{
"dropped_conditions": {
"prohibited_uses": [
"Cement, lime, gypsum or plaster of Paris manufacture, except that the manufacture of cement products shall be permitted"
]
}
}