No dimensional standards extracted
This district was identified in the ordinance, but no lot, setback or height figures were found in the sections read so far.
Extracted standards
6 individual requirements pulled out of this section’s prose, each with the sentence it came from.
Signage
- Commercial signs governed by B-1 regulations
Signs for permitted commercial uses in R-3 districts shall be governed by the regulations for the B-1 district.
- Maximum freestanding sign heightMaximum heightThe tallest a building may be, given in feet, in storeys, or both — whichever binds first.12 ft
No freestanding sign shall extend more than 12 feet above the ground, including any part of the supporting members.
- Maximum multifamilyMultifamily dwellingA building of four or more dwelling units. Where zoning is most restrictive. identification sign area10 sqftsq ftSquare feet. An acre is 43,560 sq ft; a typical suburban lot is 7,000–10,000.
One or more signs, not exceeding in the aggregate ten square feet, for the purpose of identifying a multifamily dwelling building.
- Maximum sign area per dwelling unitDwelling unitOne independent home: its own kitchen, bathroom and entrance.2 sqftsq ftSquare feet. An acre is 43,560 sq ft; a typical suburban lot is 7,000–10,000.
One sign not exceeding two square feet in area for each dwelling unit.
- Minimum sign clearance above driveway15 ft
All signs shall have a minimum clearance of fifteen feet above a driveway or alley.
- Minimum sign clearance above walkway10 ft
All signs shall have a minimum clearance of ten feet above a walkway.
From the ordinance
Signs in R-1, R-2, R-3, and R-4 districts: One sign not exceeding two square feet per dwelling unit; multifamily identification signs not exceeding ten square feet; no freestanding sign over 12 feet; clearance 10 ft above walkway, 15 ft above driveway. Commercial signs in R-3 governed by B-1.