zoneoptics
Sutter County Unincorporated, California · District

M-1

IndustrialAll Sutter County Unincorporated districts0

Dimensional standards

M-1 lot requirementsSTREETbuildable areaFront 7 ftRear 20 ftSide 15 ftMAX HEIGHT50 ftMAX FAR0.5
Plan view of the district’s stated lot requirements. Solid line: the property line. Dashed: the setback lines the ordinance imposes; a building must stay inside the tinted envelope. Drawn from the figures extracted below — illustrative, not a survey.

SetbacksSetbackThe distance a building must be held back from a lot line.

FrontSetbackThe distance a building must be held back from a lot line.
7 ft
RearSetbackThe distance a building must be held back from a lot line.
20 ft
SideSetbackThe distance a building must be held back from a lot line.
15 ft

Height & bulk

Maximum heightMaximum heightThe tallest a building may be, given in feet, in storeys, or both — whichever binds first.
50 ft
Height measured fromHeight measured fromThe reference point height is counted from — natural grade, finished grade, or the street.
avg_grade
Maximum floor area ratioFloor area ratio (FAR)Total floor area divided by lot area — an FAR of 2.0 permits 20,000 sq ft of floor on a 10,000 sq ft lot.
0.5

Uses

Permitted by right39

Conditional / special use13

Accessory2

Extracted standards

2 individual requirements pulled out of this section’s prose, each with the sentence it came from.

Other

  • Compliance with Commercial and Employment Design Checklist

    All projects subject to Design Review shall comply with Table 1500-07-3.

  • Maximum retail floor area percentage15 pct

    Retail uses shall not exceed 15 percent of the total square footage of any lot or building complex within the M-1 and M-2 Districts.

From the ordinance

Maximum FAR 0.50; Maximum Building Height Primary Structures 50 feet; Retail uses shall not exceed 15 percent of total square footage in M-1.
Table 1500-07-2; Section 1500-07-040; Section 1500-07-030 F