Sec. 7-9-23.3, 7-9-24.2, 7-9-24.4, 7-9-24.7, 7-9-24.10
Dimensional standards
Extracted standards
7 individual requirements pulled out of this section’s prose, each with the sentence it came from.
Height
Height is the vertical distance from finished grade to the highest point of a building or structure.
Other
Numerical quantities and the result of a calculation that contain a fraction of a whole number, shall be rounded up to the nearest whole number.
- Fence heightMaximum heightThe tallest a building may be, given in feet, in storeys, or both — whichever binds first. measurement
Fence/wall heights shall be measured from the base of the fence/wall to the top on interior or exterior side, whichever is greater.
- Floor area definition
The sum of the gross horizontal floor area of all floors of a building or other enclosed structure measured from the exterior finished wall surface measured in square feet.
- General rounding
Fractions of one-half (0.5) or greater shall be rounded up to the nearest whole number, and fractions of less than one-half (0.5) shall be rounded down to the nearest whole number, except as otherwise provided.
- Rear setbackSetbackThe distance a building must be held back from a lot line. reduction for alley15 ft
In computing the depth or a rear setback from any building where such setback opens on alley, private street, public park or public beach, one-half (0.5) of the width of such alley, street, park or beach may be deemed to be a portion of the rear setback, except that under this provision, no rear setback shall be less than fifteen (15) feet.
- Site coverage exclusions
Unenclosed decks, patio slabs, porches, landings, balconies, and stairways less than eighteen (18) inches in height at the surface of the deck and less than six (6) feet above grade for railings. Swimming pools and hot tubs not enclosed in roofed structures or decks. One (1) small, non-habitable accessory structure under one hundred twenty (120) square feet in area.
From the ordinance
Fractions of one-half (0.5) or greater shall be rounded up... no rear setback shall be less than fifteen (15) feet... Height is the vertical distance from finished grade to the highest point...