Dimensional standards
Lot
- Minimum lot depth
- 70 ft
Density
Extracted standards
5 individual requirements pulled out of this section’s prose, each with the sentence it came from.
Fencing & walls
- Perimeter wall/fence heightMaximum heightThe tallest a building may be, given in feet, in storeys, or both — whichever binds first.6 ft
A six-foot high solid masonry wall, or a solid wood fence with masonry posts spaced at intervals not less than 30 feet apart shall be provided around the entire perimeter.
Other
- Maximum elevation difference between stepped pads3 ft
Where mobile home sites are graded into stepped pads, there shall be no more than a three-foot vertical elevation difference between pads.
- Minimum community center area per unit500 sqftsq ftSquare feet. An acre is 43,560 sq ft; a typical suburban lot is 7,000–10,000.
A minimum of 500 square feet of net useable area per unit shall be provided for a combination of both indoor and outdoor community recreation and service facilities.
- Minimum park area20 acresacre43,560 square feet — about the size of an American football field without the end zones.
Minimum site area 20 acres.
- SetbackSetbackThe distance a building must be held back from a lot line. when abutting property line20 ft
Except for any side or rear abutting the project property line, in which case the minimum setback shall be 20 feet.
From the ordinance
New mobile home parks and mobile home subdivisions shall comply with the following minimum standards. Minimum site area 20 acres. Maximum density 7 units per acre. Setbacks 5 feet on all sides, 20 feet if abutting property line.