Dimensional standards
Density
Housing
- Single-familySingle-family dwellingOne dwelling unit on its own lot, usually detached from its neighbours.
- prohibitedProhibitedNot allowed in the district at all, short of rezoning or a variance.
- Two-family
- by_right
- Three-family
- by_right
- Four-plus family
- by_right
Servicing
- Geographic extent
- Housing opportunity sites as described in the housing element
Uses
Permitted by right1
Prohibited1
Extracted standards
2 individual requirements pulled out of this section’s prose, each with the sentence it came from.
Other
- Affordable housing requirement20 pct
All Residential Projects proposed for development pursuant to the provisions of F. 1 above shall include twenty percent (20%) of the units affordable to very low and low income households, subject to the following minimum mix of affordable dwelling units: 10% low-income, 10% very low-income.
- Usable open spaceOpen spaceLand a development must leave unbuilt, sometimes required to be usable or planted. per dwelling unitDwelling unitOne independent home: its own kitchen, bathroom and entrance.150 sqftsq ftSquare feet. An acre is 43,560 sq ft; a typical suburban lot is 7,000–10,000.
A multi-family dwelling project in the AHO Overlay shall provide 150 square feet of usable open space per dwelling unit.
From the ordinance
Residential density in the AHO Overlay district shall be zero. However, notwithstanding any other provision of this title relating to density, in the event that a project complies with the requirements of subsection F. 3 through 7 below, the residential density shall be twenty (20) to twenty-three (23) dwelling units per acre as set forth in Housing Element Program 9B.