Extracted standards
13 individual requirements pulled out of this section’s prose, each with the sentence it came from.
Other
- Compost incorporation depth6 inches
For landscape installations, compost at a rate of minimum of four cubic yards per 1,000 square feet of permeable area shall be incorporated to a depth of six inches into the soil.
- Compost incorporation rate4 cubic yardscubic yard (cy)A unit of earth volume used in grading limits — roughly one dump-truck scoop. per 1000 sqftsq ftSquare feet. An acre is 43,560 sq ft; a typical suburban lot is 7,000–10,000.
For landscape installations, compost at a rate of minimum of four cubic yards per 1,000 square feet of permeable area shall be incorporated to a depth of six inches into the soil.
- Flow sensors required for non-residential landscapes
Flow sensors that detect high flow conditions created by system damage or malfunction are required for all non-residential landscapes and residential landscapes of 5,000 sq. ft. or larger.
- Flow sensors required for residential landscapes 5,000 sq ftsq ftSquare feet. An acre is 43,560 sq ft; a typical suburban lot is 7,000–10,000. or larger5,000 sqftsq ftSquare feet. An acre is 43,560 sq ft; a typical suburban lot is 7,000–10,000.
Flow sensors that detect high flow conditions created by system damage or malfunction are required for all non-residential landscapes and residential landscapes of 5,000 sq. ft. or larger.
- High water use plants prohibitedProhibitedNot allowed in the district at all, short of rezoning or a variance. in street medians
High water use plants, characterized by a plant factor of 0.7 to 1.0, are prohibited in street medians.
- Minimum non-residential landscape area requiring water meter1,000 sqftsq ftSquare feet. An acre is 43,560 sq ft; a typical suburban lot is 7,000–10,000.
Landscape water meters... shall be installed for all non-residential irrigated landscapes of 1,000 sq. ft. but not more than 5,000 sq. ft.
- Minimum residential landscape area requiring water meter5,000 sqftsq ftSquare feet. An acre is 43,560 sq ft; a typical suburban lot is 7,000–10,000.
Landscape water meters... shall be installed for all... residential irrigated landscapes of 5,000 sq. ft. or greater.
- Maximum evapotranspiration adjustment factor for non-residential areas0.45 ratio
the evapotranspiration adjustment factor (ETAF) for the landscape project does not exceed a factor of 0.55 for residential areas and 0.45 for non-residential areas
- Maximum evapotranspiration adjustment factor for residential areas0.55 ratio
the evapotranspiration adjustment factor (ETAF) for the landscape project does not exceed a factor of 0.55 for residential areas and 0.45 for non-residential areas
- Maximum ETAF for Special Landscape Areas1 ratio
ETAF for new and existing (non-rehabilitated) Special Landscape Areas shall not exceed 1.0.
- Minimum mulch depth3 inches
A minimum three-inch layer of mulch shall be applied on all exposed soil surfaces of planting areas...
- Minimum sprinkler distribution uniformity0.65 ratio
All sprinkler heads installed in the landscape must document a distribution uniformity low quarter of 0.65 or higher using the protocol defined in ASABE/ICC 802-2014.
- Maximum slope for turf installation25 pct
Turf is not allowed on slopes greater than 25% where the toe of the slope is adjacent to an impermeable hardscape...
From the ordinance
The ETAF for a landscape project is based on the plant factors and irrigation methods selected. The Maximum Applied Water Allowance is calculated based on the maximum ETAF allowed (0.55 for residential areas and 0.45 for non-residential areas)...