Dimensional standards
Housing
Uses
Permitted by right6
Conditional / special use6
Extracted standards
5 individual requirements pulled out of this section’s prose, each with the sentence it came from.
Other
- Design permit required
In addition to projects requiring Design Permits pursuant to Section 18.108.040, the construction of new residential uses requires a Design Permit to verify conformance with Section 18.28.030.B.
- Hillside combining districtZoning districtA mapped area with one set of rules, identified by a code like R-1 or B-2. for slopes >=10%10 pct
Development on site with an average slope of ten percent or greater are subject to the requirements of Section 18.30.040 (Hillside Combining District).
- Greater imperviousImpervious coverageThe share of a lot covered by anything water cannot soak through — roofs, drives, patios. surface with CUP
Planning Commission may allow greater impervious surface with a Conditional Use Permit.
- Public sewer and water for conditionalConditional useAllowed only after a discretionary approval — usually a public hearing and a board vote. dwellings
Construction of dwellings for which conditional use permits are required are permitted only if the proposed dwelling units are served by public sewers, public water, and ingress/egress that comply with minimum fire department standards.
- Stormwater runoff control
Permanent vegetation and improvements capable of carrying stormwater runoff in a safe manner shall be installed... Sediment basins... shall be installed and maintained.
From the ordinance
Table 18.28-1 identifies land uses permitted in the Open Space (OS) and Public Facilities (PF) zoning districts. ... Construction of dwellings for which conditional use permits are required are permitted only if the proposed dwelling units are served by public sewers, public water...