Dimensional standards
Density
- Lot area per dwelling unitLot area per dwelling unitLand required for each home — the same limit as du/acre, expressed per unit instead of per acre.
- 14,520 sq ftsq ftSquare feet. An acre is 43,560 sq ft; a typical suburban lot is 7,000–10,000. (0.33 acacre43,560 square feet — about the size of an American football field without the end zones.)
Housing
- Two-family
- by_right
- Three-family
- by_right
Uses
Permitted by right13
Conditional / special use5
Extracted standards
4 individual requirements pulled out of this section’s prose, each with the sentence it came from.
Other
- Swimming pool setbackSetbackThe distance a building must be held back from a lot line. from property line10 ft
The waterline of a spa, tub, and/or swimming pool... shall be located not less than ten (10) feet from any property line
- Swimming pool setbackSetbackThe distance a building must be held back from a lot line. from structure6 ft
and not less than six (6) feet from any structure
- SetbackSetbackThe distance a building must be held back from a lot line. increase for large lots2.5 ft
Each of the minimum front, side, and rear setbacks shall be increased by two and one-half (2½) feet for single story portion and by five (5) feet for second story portion for each six thousand (6,000) square feet that the lot exceeds the minimum lot size.
- SetbackSetbackThe distance a building must be held back from a lot line. increase for second story on large lots5 ft
and by five (5) feet for second story portion for each six thousand (6,000) square feet that the lot exceeds the minimum lot size.
From the ordinance
The minimum net lot size per unit shall be fourteen thousand five hundred twenty (14,520) square feet or the minimum as required by the slope density formula... Uses permitted: single-family, duplex, triplex, accessory building, etc.