Dimensional standards
Lot
Density
- Lot area per dwelling unitLot area per dwelling unitLand required for each home — the same limit as du/acre, expressed per unit instead of per acre.
- 21,780 sq ftsq ftSquare feet. An acre is 43,560 sq ft; a typical suburban lot is 7,000–10,000. (0.5 acacre43,560 square feet — about the size of an American football field without the end zones.)
- Maximum units
- 1
Height & bulk
Housing
Uses
Permitted by right14
- single-family dwelling
- accessory buildings/structures
- horticulture
- small animals (rabbits/poultry)
- dogs/cats (max 4)
- home occupation
- renting rooms (max 2 persons)
- storage of trailer coach
- residential care homes
- supportive housing
- employee housing
- transitional housing
- accessory dwelling unit
- junior accessory dwelling unit
Conditional / special use6
Extracted standards
5 individual requirements pulled out of this section’s prose, each with the sentence it came from.
Other
- Impervious coverageImpervious coverageThe share of a lot covered by anything water cannot soak through — roofs, drives, patios. decrease for large lots or slope2 pct
The maximum impervious coverage shall be decreased by two percent (2%) for each six thousand (6,000) square feet by which the area of a parcel of property or lot exceeds the minimum lot area required in this residential zoning district; or be decreased by two percent (2%) for each five percent (5%) of slope that the parcel exceeds a ten percent (10%) average slope
- Swimming pool setbackSetbackThe distance a building must be held back from a lot line. from property line12 ft
The waterline of a spa, tub, and/or swimming pool... shall be located not less than twelve (12) feet from any property line
- Swimming pool setbackSetbackThe distance a building must be held back from a lot line. from structure8 ft
and not less than eight (8) feet from any structure
- SetbackSetbackThe distance a building must be held back from a lot line. increase for large lots5 ft
Each of the minimum front, side and rear setbacks shall be increased by five (5) feet for each ten thousand (10,000) square feet by which the area of a parcel of property or lot exceeds the minimum lot area required in this residential zoning district
- Structural coverage decrease for large lots2 pct
the structural coverage shall be decreased by two (2) percent for each six thousand (6,000) square feet by which the area of a parcel of property or lot exceeds the minimum lot area required in this residential zoning district
From the ordinance
The minimum lot area shall be twenty-one thousand seven hundred eighty (21,780) square feet or the minimum as required by the slope density formula... Minimum lot frontage shall be one hundred (100) feet... Maximum building height: 21 ft for single-story, 30 ft for two-story, max 2 stories. Maximum structural coverage 30%, impervious coverage 40%.