22.42.048
Dimensional standards
Height & bulk
Servicing
- Geographic extent
- Unincorporated areas of Marin County
Extracted standards
3 individual requirements pulled out of this section’s prose, each with the sentence it came from.
Other
- Design review waiver criteria
A. The project is limited to single-family residential development, including associated accessory structures. B. The project is not located within an area governed by a Master Plan, unless that Master Plan provides for Site Plan Review. C. The development would meet the standards for height and setbacks established by the R1:B3 zoning district and Chapter 22.20. D. The development would not exceed a floor area of 3,500 square feet E. The development would not exceed a floor area ratio of 30 percent. F. The development would not occur in a Ridge and Upland Greenbelt Area.
- Design review waiver maximum floor area ratioFloor area ratio (FAR)Total floor area divided by lot area — an FAR of 2.0 permits 20,000 sq ft of floor on a 10,000 sq ft lot.30 pct
The development would not exceed a floor area ratio of 30 percent.
- Design review waiver maximum floor area3,500 sqftsq ftSquare feet. An acre is 43,560 sq ft; a typical suburban lot is 7,000–10,000.
The development would not exceed a floor area of 3,500 square feet
From the ordinance
Design Review shall be waived for eligible projects and the project shall instead be subject to the requirements of Chapter 22.52 (Site Plan Review). Only those projects that comply with the criteria below are eligible for Design Review waiver.