Dimensional standards
Lot
Extracted standards
3 individual requirements pulled out of this section’s prose, each with the sentence it came from.
Density
- Base minimum lot areaMinimum lot areaThe smallest parcel on which the district allows anything to be built. per dwelling unitDwelling unitOne independent home: its own kitchen, bathroom and entrance.2,420 sqftsq ftSquare feet. An acre is 43,560 sq ft; a typical suburban lot is 7,000–10,000.
The 'base' density allowance is hereby defined as the requirement of at least two thousand four hundred twenty square feet of building site area per dwelling unit.
- Reduced minimum lot areaMinimum lot areaThe smallest parcel on which the district allows anything to be built. per dwelling unitDwelling unitOne independent home: its own kitchen, bathroom and entrance. with bonus1,895 sqftsq ftSquare feet. An acre is 43,560 sq ft; a typical suburban lot is 7,000–10,000.
The required minimum building site area per dwelling unit for a residential project under these zones may be decreased from two thousand four hundred twenty square feet to one thousand eight hundred ninety-five square feet.
- Maximum density bonusDensity bonusExtra units allowed above the base cap in exchange for something — usually affordable homes. points525 points
The maximum total point score allowed to be earned for any project shall be five hundred twenty-five.
From the ordinance
The required minimum building site area per dwelling unit for a residential project under these zones may be decreased from two thousand four hundred twenty square feet to one thousand eight hundred ninety-five square feet, according to the procedures and allowances of this section.