§ 154.2.163
Dimensional standards
Servicing
- Geographic extent
- All lands identified in the CAP as designated by the Board of Supervisors and shown on the general CAP map, including Resource Protection Areas (RPA) and Resource Management Areas (RMA)
Extracted standards
6 individual requirements pulled out of this section’s prose, each with the sentence it came from.
Other
- Nonpoint source pollution reduction for agriculturalAgricultureRaising crops or livestock, generally including the structures that serve them. uses40 pct
achieve a 40% reduction in nonpoint source pollution from agricultural uses
- Resource Protection Area buffer width100 ft
A 100-foot vegetated buffer area located adjacent to and landward of the components listed in the subsections (D)(1)(a)-(f) above and along both sides of any water body with perennial flow.
- Land disturbance threshold requiring plan of development2,500 sqftsq ftSquare feet. An acre is 43,560 sq ft; a typical suburban lot is 7,000–10,000.
Any development or redevelopment 2,500 square feet or greater of land disturbance shall require the approval of a plan of development
- No increase in imperviousImpervious coverageThe share of a lot covered by anything water cannot soak through — roofs, drives, patios. cover for redevelopment
Redevelopment may be permitted only if there is no increase in the amount of impervious cover and no further encroachment within the RPA.
- Nonpoint source pollution reduction for redevelopment10 pct
achieve a 10% reduction in nonpoint source pollution from redevelopment
- Seaward limit for encroachments50 ft
The encroachment may not extend into the seaward 50 feet of the buffer area
From the ordinance
A 100-foot vegetated buffer area located adjacent to and landward of the components listed in the subsections (D)(1)(a)-(f) above and along both sides of any water body with perennial flow.