Dimensional standards
Height & bulk
Servicing
- Geographic extent
- Residential districts
Extracted standards
15 individual requirements pulled out of this section’s prose, each with the sentence it came from.
Signage
- Nonresidential use in residential districtZoning districtA mapped area with one set of rules, identified by a code like R-1 or B-2. maximum signs of any type1 count
No more than 1 of any type of sign shall be permitted per lot
- Nonresidential use in residential districtZoning districtA mapped area with one set of rules, identified by a code like R-1 or B-2. maximum signs per lot2 count
up to a maximum of 2 per lot
- Nonresidential use in residential districtZoning districtA mapped area with one set of rules, identified by a code like R-1 or B-2. maximum signs per street frontageFrontageThe length of a lot line that touches a public street.1 count
Maximum number of signs: 1 per street frontage up to a maximum of 2 per lot
- Nonresidential use in residential districtZoning districtA mapped area with one set of rules, identified by a code like R-1 or B-2. monument/wall sign maximum area10 sqftsq ftSquare feet. An acre is 43,560 sq ft; a typical suburban lot is 7,000–10,000.
Monument and wall signs shall be no more than 10 square feet
- Nonresidential use in residential districtZoning districtA mapped area with one set of rules, identified by a code like R-1 or B-2. projecting sign maximum area5 sqftsq ftSquare feet. An acre is 43,560 sq ft; a typical suburban lot is 7,000–10,000.
Projecting signs shall be no more than 5 square feet
- Nonresidential use in residential districtZoning districtA mapped area with one set of rules, identified by a code like R-1 or B-2. sign placement
Signs shall not be placed in side or rear yards, except for through lots, which may have a sign in each of the front yards
- Nonresidential use in residential districtZoning districtA mapped area with one set of rules, identified by a code like R-1 or B-2. sign setbackSetbackThe distance a building must be held back from a lot line. from property line10 ft
Signs in front yards shall be setback a minimum of 10 feet from property lines, public right of way, or access easements
- Nonresidential use in residential districtZoning districtA mapped area with one set of rules, identified by a code like R-1 or B-2. total sign area per lot30 sqftsq ftSquare feet. An acre is 43,560 sq ft; a typical suburban lot is 7,000–10,000.
Total area of signage per lot: 30 square feet
- Nonresidential use in residential districtZoning districtA mapped area with one set of rules, identified by a code like R-1 or B-2. wall sign maximum heightMaximum heightThe tallest a building may be, given in feet, in storeys, or both — whichever binds first.10 ft
Height of wall sign: No more than 10 feet from the ground
- Residential development monument sign per external street entrance1 count
One monument sign shall be authorized per external street entrance into the subdivision or community
- Residential development sign location
Signs shall only be located on commonly owned land within the subdivision or community
- Individual residential lot address sign permitted1 count
One permanent address sign. No sign permit shall be required for such sign.
- Individual residential lot lawn sign permit required0 boolean
Lawn signs shall be permitted without a sign permit
- Individual residential lot maximum additional signs1 count
not more than 1 additional sign
- Individual residential lot maximum flags2 count
Not more than 2 flags
From the ordinance
One permanent address sign. No sign permit shall be required for such sign. Not more than 2 flags, and not more than 1 additional sign, shall be permitted per lot.