King William County Unincorporated, Virginia · General provision
Sec. 86-455
Dimensional standards
Lot
Density
- Maximum density
- 0.07 du/acredu/acreDwelling units per acre — the number of homes allowed on each acre of land.
- Lot area per dwelling unitLot area per dwelling unitLand required for each home — the same limit as du/acre, expressed per unit instead of per acre.
- 653,400 sq ftsq ftSquare feet. An acre is 43,560 sq ft; a typical suburban lot is 7,000–10,000. (15 acacre43,560 square feet — about the size of an American football field without the end zones.)
- Maximum units
- 7
Extracted standards
4 individual requirements pulled out of this section’s prose, each with the sentence it came from.
Other
- Health official certification for on-site sewage
If on-site disposal systems are to be utilized in a farmstead subdivision, the plat shall not be approved until the health official affixes his signature to a statement on the plat certifying that the lots are generally suitable for the installation of such on-site systems.
- Minimum diameter for lot corner monuments0.75 in
iron pipe not less than three-fourths inch in diameter or iron rod not less than one-half inch in diameter
- Minimum compacted travel surface depth for private streets6 in
Minimum six-inch compacted travel surface depth.
- Shared access easement width for two-lot subdivisions50 ft
a shared access shall be provided on a 50-foot-wide easement
From the ordinance
creating two to seven lots with a minimum lot size of 15 acres