Sec. 7-2002.A.3
Dimensional standards
Servicing
- Applies near
- Resource protection area
- Geographic extent
- Applies to sites that contain an area designated as a resource protection area as determined by the county.
Extracted standards
5 individual requirements pulled out of this section’s prose, each with the sentence it came from.
Other
- BMP locations shown
Where best management practices (BMPs) are proposed, the exact location of such BMPs shall be shown in addition to any design details and notations necessary to insure the installation of such features.
- Chesapeake Bay Preservation Area landscaping shown
All landscaping proposed in compliance with the Chesapeake Bay Preservation Area Ordinance shall be shown on the plot plan.
- Topography at 2-foot contour intervals2 ft
The topography of the site shall be provided at no less than two-foot contour intervals and preferably at one-foot intervals.
- Resource protection area buffer100 ft
The resource protection area shall be accurately shown including all water features identified in the county's Chesapeake Bay Preservation Area Ordinance and the required one-hundred-foot buffer.
- Water quality impact assessment for reduced buffer
Where a buffer of less than one hundred (100) feet is proposed, a water quality impact assessment shall be prepared and submitted as part of the application.
From the ordinance
For sites that contain an area designated as a resource protection area as determined by the county: a. The plot plan shall meet all of the criteria identified under [subsection] 2. above. In addition, the following information shall be shown or provided as part of the application...