§153.051 Industrial District
Dimensional standards
Uses
Permitted by right16
- assembly of electrical appliances
- automobile assembling
- blacksmith shop
- laboratories
- manufacture of various products
- manufacture from prepared materials
- pottery
- building material sales yard
- contractors' equipment storage
- cabinets, furniture and upholstery shops
- boatbuilding
- monumental stone works
- veterinary hospital
- wholesale businesses
- truck terminals
- public utility facilities
Conditional / special use2
Prohibited2
- residential uses
- any use not allowed by right, by accessory use or by conditional use
Extracted standards
5 individual requirements pulled out of this section’s prose, each with the sentence it came from.
Other
- All uses in completely enclosed buildings
All uses shall be conducted within completely enclosed buildings except for parking and loading, exterior storage and other accessory uses which by their nature must exist outside a building.
- Exterior storage allowed in side/rear with screening
Exterior storage may be permitted in the side and rear of the principal building only, provided the location, extent and screening of storage is approved as a part of the site plan by the Planning Commission; and further, provided that exterior storage shall be screened from public view by a suitable fence, wall or hedge not exceeding 15 feet in height with the stored materials to be kept at least two feet below the top of such screen.
- Rear yardYardThe open space left between a building and its lot line — the space a setback creates. when adjoining residential districtZoning districtA mapped area with one set of rules, identified by a code like R-1 or B-2.50 ft
Rear yards shall be a minimum of 50 feet where the lot adjoins a residential district.
- Side yardYardThe open space left between a building and its lot line — the space a setback creates. when adjoining residential districtZoning districtA mapped area with one set of rules, identified by a code like R-1 or B-2.50 ft
Side yards shall be a minimum of 50 feet where the lot adjoins a residential district.
- Site plan review required
For all proposed development within the I District, prior to issuance of a building permit, a site plan shall be submitted to the Planning Commission.
From the ordinance
Maximum lot coverage shall not exceed 50% of total lot area. Maximum height shall be 35 feet above curb level. Front yards minimum 40 feet. Side yards minimum 25 feet (50 if adjoins residential). Rear yards minimum 25 feet (50 if adjoins residential).