Sec. 53-393, 53-394, 53-395, 53-396
Dimensional standards
Lot
Density
Height & bulk
Uses
Permitted by right13
- single-family dwelling
- two-family dwelling
- multiple-family dwellings
- churches
- schools
- professional offices
- clubs and lodges
- parks, playgrounds, and noncommercial recreational facilities
- neighborhood commercial retail and office uses
- public utilities
- off-street parking
- accessory uses and structures
- home occupation
Conditional / special use4
- community centers
- child care centers
- adult day care centers
- facilities, activities and operations provided by a duly constituted unit of government
Extracted standards
8 individual requirements pulled out of this section’s prose, each with the sentence it came from.
Other
- Maximum commercial development area10 pct
Commercial development serving the PUD shall be allowed up to a maximum of no more than ten percent of the total gross area in the PUD.
- Maximum lot length to width ratio5 ratio
Maximum length to width ratio for each lot must not exceed 5 to 1.
- Maximum open spaceOpen spaceLand a development must leave unbuilt, sometimes required to be usable or planted. in floodplainFloodplainLand expected to flood at a stated frequency, where building carries extra conditions., wetlands, public facilities, utility uses, or slopes over 15%5 pct
Not more than one-fourth of this area (five percent of gross) may be in any combination of 100-year flood plain, wetlands, public facilities, utility uses or slopes in excess of 15 percent.
- Maximum PUDPlanned unit development (PUD)A negotiated district where a whole site is approved to its own bespoke plan. area100 acresacre43,560 square feet — about the size of an American football field without the end zones.
A PUD must include at least ten gross acres and not more than 100 gross acres of contiguous land fronting upon an existing paved major collector or arterial highway.
- Minimum lot areaMinimum lot areaThe smallest parcel on which the district allows anything to be built. for multiple-family detached dwellings40,000 sqftsq ftSquare feet. An acre is 43,560 sq ft; a typical suburban lot is 7,000–10,000.
Multiple-family detached dwellings shall be on lots with a minimum area of not less than 40,000 square feet.
- Minimum lot areaMinimum lot areaThe smallest parcel on which the district allows anything to be built. for two-family attached dwellings2,000 sqftsq ftSquare feet. An acre is 43,560 sq ft; a typical suburban lot is 7,000–10,000.
Two-family attached dwellings shall be on lots with a minimum area of not less than 2,000 square feet.
- Minimum PUDPlanned unit development (PUD)A negotiated district where a whole site is approved to its own bespoke plan. area10 acresacre43,560 square feet — about the size of an American football field without the end zones.
A PUD must include at least ten gross acres and not more than 100 gross acres of contiguous land fronting upon an existing paved major collector or arterial highway.
- Mixed use dwellings must be on second floor or higher
All dwelling units must be located upon the second or higher floors.
From the ordinance
A PUD may have a total, overall density of up to seven units per net acre. Single-family dwellings shall be on lots with minimum area of not less than 8,000 square feet. Maximum lot coverage is 60 percent for structures and 75 percent for impervious surfaces. Open space in the amount of 20 percent of the gross area of the PUD shall be provided.