Gloucester County Unincorporated, Virginia · General provision
Sec. 34-120
Dimensional standards
Servicing
- Geographic extent
- All lands within incorporated limits of the town
Extracted standards
4 individual requirements pulled out of this section’s prose, each with the sentence it came from.
Other
- Minimum block corner radius25 ft
Block corner radii dimensions shall be shown having a minimum of 25-foot radius. (Sec. 34-120(a)(9))
- Maximum final plat scale200 ft/inch
The final plat shall be at a scale of no more than 200 feet to the inch. (Sec. 34-120(a))
- Margin requirements
At least a one-half-inch margin on each of three sides and a three-inch margin on the left side. (Sec. 34-120(a))
- Sheet size24 inches
The size of each sheet shall be 24 by 36 inches. (Sec. 34-120(a))
From the ordinance
Final plat plans shall be prepared by a surveyor registered in the state... The final plat shall be at a scale of no more than 200 feet to the inch. (Sec. 34-120(a))