Albemarle County Unincorporated, Virginia · General provision
Sec. 4.19 - Setbacks and stepbacks in residential districts
Dimensional standards
Servicing
- Geographic extent
- R-1, R-2, R-4, R-6, R-10, R-15, PRD, and PUDPlanned unit development (PUD)A negotiated district where a whole site is approved to its own bespoke plan. districts
Extracted standards
8 individual requirements pulled out of this section’s prose, each with the sentence it came from.
Other
- Infill front maximum setbackSetbackThe distance a building must be held back from a lot line.
Front-Maximum: None
- Infill garage maximum setbackSetbackThe distance a building must be held back from a lot line.
Garage-Maximum: None
- Infill rear maximum setbackSetbackThe distance a building must be held back from a lot line.
Rear-Maximum: None
- Infill side maximum setbackSetbackThe distance a building must be held back from a lot line.
Side-Maximum: None
- Minimum stepback15 ft
The minimum 15-foot stepback applies to all buildings on the property and may be reduced by special exception.
- Non-infill garage maximum setbackSetbackThe distance a building must be held back from a lot line.
Garage-Maximum: None
- Non-infill rear maximum setbackSetbackThe distance a building must be held back from a lot line.
Rear-Maximum: None
- Non-infill side maximum setbackSetbackThe distance a building must be held back from a lot line.
Side-Maximum: None
From the ordinance
The following shall apply within the R-1, R-2, R-4, R-6, R-10, R-15, PRD, and PUD districts