Dimensional standards
Extracted standards
16 individual requirements pulled out of this section’s prose, each with the sentence it came from.
Signage
- Minimum interval between changeable message changes12 sec
The message shall not be changed more than once every 12 seconds
- Maximum heightMaximum heightThe tallest a building may be, given in feet, in storeys, or both — whichever binds first. for construction site signs6 ft
and a height of six feet
- Maximum area for construction site signs16 sqftsq ftSquare feet. An acre is 43,560 sq ft; a typical suburban lot is 7,000–10,000.
Such signs shall not exceed an area of 16 square feet and a height of six feet.
- Minimum distance of construction sign from property lines20 ft
Each sign shall be at least 20 feet from contiguous property lines of adjacent landowners
- Minimum distance of construction sign from right-of-way5 ft
and at least five feet from any right-of-way.
- Signs in Entrance Corridor require certificate of appropriateness
For signs within the Town's Entrance Corridor, such permit shall conform to the requirements of such district and require certificate of appropriateness issued by the Planning Commission.
- Signs in Old and Historic DistrictHistoric districtAn area where exterior changes need design review to protect its character. require certificate of appropriateness
Signs within the Town's Old and Historic District shall conform to the requirements of such district and require a certificate of appropriateness issued by the Historic Preservation Review Board (HPRB).
- Maximum sign illumination during daytime10,000 nits
Illumination shall be no greater than 10,000 nits or footcandles from sunrise to sunset
- Maximum sign illumination at night700 nits
or 700 nits or footcandles from sunset to sunrise
- Minimum sign setbackSetbackThe distance a building must be held back from a lot line. from right-of-way (ratio of heightMaximum heightThe tallest a building may be, given in feet, in storeys, or both — whichever binds first.)0.5 ratio
The minimum setback from any right-of-way, unless otherwise specified, is half the height of the sign.
- ProhibitedProhibitedNot allowed in the district at all, short of rezoning or a variance. signs include flashing, roof, off-premise, etc.
Any flashing sign, except those officially erected for safety purposes; Signs on the roof surface; Off-premise signs, unless specifically permitted
- Maximum extension of projecting sign beyond building face6 ft
Projecting signs shall not extend more than six feet beyond the face of the building
- Minimum heightMaximum heightThe tallest a building may be, given in feet, in storeys, or both — whichever binds first. of projecting sign over public walkway8 ft
Signs projecting over public walkways shall be a minimum height of eight feet from grade level to the bottom of the sign.
- Maximum area for temporary off-premise signage on residential parcels32 sqftsq ftSquare feet. An acre is 43,560 sq ft; a typical suburban lot is 7,000–10,000.
Temporary off-premise signage is not to exceed 32 square feet.
- Sign permit required
No sign shall be erected, installed, altered, modified, refaced, rehung, or replaced without obtaining a permit pursuant to this article
- Maximum duration of temporary sign permit per quarter30 days
Temporary sign permits shall be issued for no more than 30 days per quarter.
From the ordinance
The minimum setback from any right-of-way, unless otherwise specified, is half the height of the sign.