Article III, Subdivisions

Other

• Minimum block corner radius25 ft

  block corner radii dimensions shall be shown having a minimum of 25-foot radius

• Bond for required improvements125 percent

  a bond shall be posted by the developer equaling 125 percent of the engineer's estimated cost of completing improvements required by this article and/or the final development order.

• Maximum lots served by collector street60 lots

  Shall serve no more than 60 lots, tracts or parcels.

• Minimum cul-de-sac right-of-way diameter100 ft

  Cul-de-sac rights-of-way shall have a minimum diameter of 100 feet.

• Minimum area for large scale plat10 acresacre43,560 square feet — about the size of an American football field without the end zones.

  Large scale plats are those that are greater than ten acres or any plat that will require roadway improvements, drainage improvements or other required subdivision improvements whether private, public, or possible dedication of land to the town.

• Maximum days before refusal to accept plat20 working days

  If applicant is late for more than 20 working days, the clerk shall refuse to accept the plat and advise the applicant he must refile for final development approval with the town.

• Penalty for late filing of plat1 dollars per day

  Failure by the applicant to comply with time requirements for filing appropriate documents with the county clerk shall result in a penalty of $1.00 per day for each day applicant is late.

• Maximum lots served by local street30 lots

  Shall serve no more than 30 lots, tracts or parcels.

• Minimum street intersection angle60 degrees

  No street shall intersect another at an angle of less than 60 degrees.

• Minimum street jog centerline offset200 ft

  Street jogs with centerline offsets of less than 200 feet shall be avoided, except where topographic situations make this provision impractical.

• Maximum plat scale200 feet per inch

  The preliminary plat shall be at a scale of not more than 200 feet to the inch.

• Plat sheet heightMaximum heightThe tallest a building may be, given in feet, in storeys, or both — whichever binds first.36 inches

  The size of each sheet shall be 24 inches by 36 inches

• Plat sheet width24 inches

  The size of each sheet shall be 24 inches by 36 inches

• Right-of-way dedication along section lines50 ft

  50 feet on each side of all section lines shall be dedicated for roadway purposes.

• Maximum area for small scale plat10 acresacre43,560 square feet — about the size of an American football field without the end zones.

  the plat will be limited to ten acres or less where there are no provisions in this Code requiring roadway improvements, drainage improvements or other required public improvements.