Dimensional standards
Lot
- Minimum lot depth
- 5 ft
Extracted standards
9 individual requirements pulled out of this section’s prose, each with the sentence it came from.
Lot
- Minimum lot frontageFrontageThe length of a lot line that touches a public street. as percentage of lot widthLot widthHow wide a lot must be, usually measured at the front setback line.80 pct
Lot frontages within the R-2, R-4, R-8, and R-12 zoning districts shall not be less than 80% of the required lot width.
- Maximum lot depth to width ratio5 ratio
The depth of a lot shall not exceed five times its width.
- Maximum percentage of pipestem lots in a subdivision section10 pct
Pipestem lots shall constitute no more than 10% of the lots in any one section of a subdivision and shall be used only for single-family, detached dwellings.
- Maximum pipestem driveway length200 ft
A pipestem driveway shall serve no more than three lots, shall have a width of no less than 12 feet, and shall have a length not greater than 200 feet from the street right-of-way.
- Minimum pipestem driveway width12 ft
A pipestem driveway shall serve no more than three lots, shall have a width of no less than 12 feet, and shall have a length not greater than 200 feet from the street right-of-way.
Other
- Maximum block depth for multifamilyMultifamily dwellingA building of four or more dwelling units. Where zoning is most restrictive.600 ft
For multifamily residential uses and mixed use developments with a residential component, the depth of a block shall be not less than 250 feet and not more than 600 feet.
- Maximum block length600 ft
The length of a block shall be not less than 250 feet and not more than 600 feet.
- Minimum block depth for multifamilyMultifamily dwellingA building of four or more dwelling units. Where zoning is most restrictive.250 ft
For multifamily residential uses and mixed use developments with a residential component, the depth of a block shall be not less than 250 feet and not more than 600 feet.
- Minimum block length250 ft
The length of a block shall be not less than 250 feet and not more than 600 feet.
From the ordinance
The length of a block shall be not less than 250 feet and not more than 600 feet. Lot frontages within the R-2, R-4, R-8, and R-12 zoning districts shall not be less than 80% of the required lot width. The depth of a lot shall not exceed five times its width.