Article 19 - Substandard Subdivisions
Dimensional standards
Lot
Servicing
- Geographic extent
- Applies to resubdivision of substandard subdivisions in any zoning districtZoning districtA mapped area with one set of rules, identified by a code like R-1 or B-2.
Extracted standards
4 individual requirements pulled out of this section’s prose, each with the sentence it came from.
Other
- Average lot areaMinimum lot areaThe smallest parcel on which the district allows anything to be built. formula
The average area of the lots in such a resubdivision shall be not less than the average area of the lots in the subdivision heretofore lawfully dedicated and recorded, plus one-half (½) the difference between that average and the average area required for a lot in the zoning district in which the subdivision lies.
- Corner lot minimum width and depth90 ft
nor shall any corner lot have either a width or a depth of less than ninety (90) feet.
- Maximum number of lots
the total number of lots permitted in the resubdivision of the substandard subdivision shall not exceed the total number of lots in the original subdivision being resubdivided, plus the total number of lots which the existing restrictions applicable to the zoning district in which the land lies would permit in such undivided parcels
Setback
The building setback line in resubdivisions of subdivisions developed as substandard subdivisions shall be the same as the building setback line requirements in the zoning district in which the property lies.
From the ordinance
The minimum lot area in such subdivision shall be not less than ten percent (10%) smaller than the above-described average lot area, except that no lot shall in any case contain an area of less than eight thousand five hundred (8,500) square feet...