Culpeper County Unincorporated, Virginia · General provision
9-4A
Dimensional standards
Servicing
- Geographic extent
- Commercial, industrial, and residential districts R-1, R-2, R-3, R-4, PUDPlanned unit development (PUD)A negotiated district where a whole site is approved to its own bespoke plan.
Extracted standards
6 individual requirements pulled out of this section’s prose, each with the sentence it came from.
Other
- Maximum alley grade for first 25 feet from street3 pct
except that the grade shall not exceed three (3) percent for the first twenty-five (25) feet from the street connection.
- Maximum alley grade10 pct
The maximum grade for an alley shall be ten (10) percent
- Minimum alley right-of-way width20 ft
Alleys not less than twenty (20) feet in right-of-way width
- Minimum paved travel way width15 ft
A minimum paved travel way of fifteen (15) feet shall be provided.
- Minimum setbackSetbackThe distance a building must be held back from a lot line. from alley easement to structures10 ft
A minimum setback of ten (10) feet shall be required from the edge of the easement to any accessory structure, garage, or other structure.
- Minimum setbackSetbackThe distance a building must be held back from a lot line. from alley intersection20 ft
A twenty-foot setback shall be provided from an alley intersection and the first structure, parking space, or any street tree planting.
From the ordinance
Alleys not less than twenty (20) feet in right-of-way width may be provided in the rear of all commercial and industrial properties unless other provisions are made for parking and service. Alleys shall also be permitted in the following residential districts: R-1, R-2, R-3, R-4, and PUD.