zoneoptics
Placer County Unincorporated, California · General provision

Article 17.12.010

All Placer County Unincorporated districts0

Dimensional standards

lot requirementsSTREETMin width 500 ftMIN LOT AREA10 ac
Plan view of the district’s stated lot requirements. Solid line: the property line. Dashed: the setback lines the ordinance imposes; a building must stay inside the tinted envelope. Drawn from the figures extracted below — illustrative, not a survey.

Lot

Minimum lot areaMinimum lot areaThe smallest parcel on which the district allows anything to be built.
435,600 sq ftsq ftSquare feet. An acre is 43,560 sq ft; a typical suburban lot is 7,000–10,000. (10 acacre43,560 square feet — about the size of an American football field without the end zones.)
Minimum lot widthLot widthHow wide a lot must be, usually measured at the front setback line.
500 ft

Housing

Single-familySingle-family dwellingOne dwelling unit on its own lot, usually detached from its neighbours.
prohibitedProhibitedNot allowed in the district at all, short of rezoning or a variance.
Two-family
prohibitedProhibitedNot allowed in the district at all, short of rezoning or a variance.
Three-family
prohibitedProhibitedNot allowed in the district at all, short of rezoning or a variance.
Four-plus family
prohibitedProhibitedNot allowed in the district at all, short of rezoning or a variance.

Uses

Permitted by right4

Conditional / special use15

From the ordinance

Minimum Lot Area: Ten acres... Minimum Lot Width: Five hundred feet.
Article 17.12.010