Highlighted below: 2 of 2 extracted standards. Sections and highlights carry their own anchors.
CHAPTER 18.46 - QMD—QUARRY, MINING AND DRILLING DISTRICT#
18.46.010 - Land use regulations.#
Land use regulations are:
A. Permitted Uses. Quarrying, mining, and drilling except surface mining;
B. Uses Allowed with Zoning Permit. None specified;
C. Uses Allowed with Conditional Use Permit.
- Surface mining;
- Manufacturing;
- Storage;
- Recreation area;
- Dangerous or unusual devices or material manufacturing, testing and storage;
- Refuse disposal sites (See Chapter 18.94);
- Cemeteries and mausoleums (See Chapter 18.94);
- Laboratories for testing, experimental or analytical purposes. (See Chapter 18.94.)
(Ord. 525 § 1(part), 1989).
18.46.020 - Structure location regulations.#
(See also Sections 18.98.010—18.98.090.) Structure location regulations are:
| Regulation | Minimum |
|---|---|
| Setback from edge of right-of-way | ___ feet |
| Side yard offset | ___ feet |
| Rear yard offset | ___ feet |
All locations of structures, ore, tailing, ponds, equipment and similar things are subject to approval by the zoning agency through conditional use permit.§
(Ord. 525 § 1(part), 1989).
18.46.030 - Structure height regulations.#
(See also Sections 18.98.100—18.98.130.) Structure height regulations are:
| Regulation | Maximum |
|---|---|
| Principal building height | ___ feet |
| Accessory building height | ___ feet |
All structure heights over sixty feet are subject to approval by the zoning agency through conditional use permit.§
(Ord. 525 § 1(part), 1989).
18.46.040 - Lot dimension regulations.#
(See also Section 18.100.010.) Lot dimension regulations are:
| Regulation | Requirement |
|---|---|
| Lot area | ___ square feet, minimum |
| Average lot width | ___ feet, minimum |
| Lot length to width ratio permitted | ___ |
| Dwelling floor area to lot area ratio permitted | ___ maximum |
| Total buildings area to lot area ratio permitted | Twenty percent, maximum |
Dwellings and commercial uses are not permitted in this district.
(Ord. 525 § 1(part), 1989).